Kuna Installation Guide

We’ve designed Kuna to replace your existing light fixture in a few easy steps. Just take down your old fixture and connect Kuna to your existing power wires, then mount Kuna to your junction box. Printed copies of our Quick Start Guide and Installation Guide are included in your Kuna's box.

WARNING: 120V AC light installation requires knowledge of lighting and electrical systems. Do not attempt to install Kuna yourself if you are unfamiliar with outdoor lighting. Please contact a qualified electrician if you have any questions or need assistance. 

 

  

Step 1 - Disconnect Power and Adjust Bracket

Disconnect power at fuse or circuit breaker before installing the light. 

Before installing your Kuna device, make sure that power is turned off at your circuit breaker and at your wall switch, so your current outdoor light is not receiving power. Once you have verified that your current outdoor light is no longer receiving power, it's ok to start the installation process! 

Ensure fixture screws and nuts are inserted into the bracket as shown. Adjust the swivel angle based on your junction box.

Your Kuna contains two different screw sizes, so you can mount the bracket pieces parallel or perpendicular, depending on how your junction box is set up.

 

Step 2 - Fasten Bracket to Junction Box

Tighten middle screws in the bracket so it’s firm and doesn’t wobble.

Fasten bracket to junction box using two junction box screws. Choose short or long pair as needed.

 

Step 3 - Adjust and Tighten Screws

Use the fixture screws length indicator to adjust the length of the two screws from the wall, then tighten the two nuts.

 

Step 4 - Suspend Light with Holding Hook

Use holding hook to suspend the light and free your hands for wiring.

4a.          4b.  

Connect the bottom of the hook (square) to the right screw pole (4a), then hand the top of the hook (triangle) on the mounting bracket (4b).

 

Step 5 - Connect the Wires

Use wire nuts to connect Black to Black wires. Insert both wires all the way into the nut and twist until secure. Then repeat for the white wires and for the ground wires.

Wall wire colors may vary.

Recommended: Use a voltage detector to confirm the power is off.

 

Step 6 - Align Fixture Screws

Holding the light fixture with both hands, align the two fixture-long screws into the light fixture screw posts.

 

Step 7 - Install Bulb and Reconnect Power

Mount the light fixture to the long screws as shown, then install both decorate nuts. Install a light bulb (maximum 100W). Kuna recommends an A-15 LED or CFL light bulb for best results.

Apply silicone sealant between the wall and light fixture (optional).

Reconnect power at fuse or circuit breaker after installing the light.

 

Step 8 - Adjust Camera, Finish Setup with the Kuna App

For Kuna Only: Adjust the camera lens angle. Use two fingers to loosen up the locking ring by turning it counter clockwise. Then, lock it up by turning the ring clockwise. Before making final adjustments, check the video feed on your device after downloading the Kuna app and setting up Wi-Fi.

For Kuna Companion Only: Open the Kuna app and follow the instructions to pair your Kuna light with your Kuna companion.

 

Still Have Questions?

Phone Support: M-F 8:30am to 3:30pm PST (888) 804-5862

Contact Us